De Tango help

OK, I'm going to put my testees on the line and have a go at De-Tangoing my Blobeye headlights.

Ive had a look at a few guides that people have done and think I can pull this off.

Three questions for anyone who's already done this :

Do I really need to use some extra sealant in addition to the original mastik ?
Can I heat the units up with a hairdryer / heatgun instead of sticking them in the oven ?
Exactly what bulbs do I need to replace the OEM ones ?

Ive looked through loads of threads and also on ebay and I cant figure out which bulbs to buy. If anyone has got a link I'll get them ordered now.

Not done it on a scoob but done it on a few others, you will need silvertec bulbs, i dont think heat gun will be hot enough and i would say yes use additional sealant, something like tiger seal or stickaflex or summit

I preferred using a heat gun when doing mine mate. A little extra sealant wouldn't hurt however I didn't use/need any. Be careful not to get finger prints on the inside of the lense or chrome bits inside.

I used a hair dryer when i did mine and DanG's and put them back together using a bit silicone sealant, so far no goldfish in mine or Dan's. if i remeber rightly there's at least 1 or 2 hidden screws behind some foam padding on the back of the headlights just to keep you on your toes

I kept on blowing the Silvertec ones and the light they give off i thought was a bit wank so i've got yellow bulbs in from a Toyota dealer as the price of them from Subaru is silly, see pic below, not full on clear but better than before

I'm dying to do mine too but haven't plucked up the courage just yet.. we should hold a "de-tangoing workshop" somewhere and do them all together lol

Done mine last year in the oven just low heat be patient though lol,
Once you have taken the Orange surround out n cleaned things POP back in oven before resealing them .