Blob to Hawk Centre Console Coversion

Dave yours is a ringer thats why lol

greigy27 wrote:

Have you went and bought it?

Who me, didnt you read my post ?

I just said earlier on in the thread that it looked like a right pain in the arse and I wasnt going to do it.

..........should have it by the end of the week.

Phase 1 of this starts tonight. I'll be pulling all of the bits out and arranging them in nice little piles.

Phase 2 will start about 30 mins after Phase 1 is complete, where I'll start swearing like a truck driver and wishing I'd never started.

Phase 3 will probably be a slow frustrating reverse of Phase 1.

I will continue to repeat this silly loop every night this week until I give in and ring Kindon.

keith there not that bad, i have all my dash out when fitting the boost control and other electrical bits.

I am sure you can doing it, if it wont fit use a hammer if it breaks then it needed replacing.

Task completed this weekend, dunno what everyone was on about. Absolute piece of p*ss.

How it foxed someone who normally builds engines for a living is completely beyond me.

Pictures will be posted in due course.

kgt wrote:

Task completed this weekend, dunno what everyone was on about. Absolute piece of p*ss.


How it foxed someone who normally builds engines for a living is completely beyond me.

Pictures will be posted in due course.

nice one Keith

Finally.


[You must be registered and logged in to see this link.]

Looks awsome mate,especially liking the center pods.

Scoobyworld jobby Martin, rather pricey for what they are, but a cheap one would have spoiled things. My grandad was a proper pedant and I was always told, "Either do it properly or dont do it at all" so Ive continued in that vein. Ive got my mother and him to thank for my OCD.....wish he'd left me cash instead

looks good bud

Finishing touch, mounted the wing mirror switch in its newly decorated surround. Now I can put my feet up and contemplate the next job


[You must be registered and logged in to see this link.]